InsuliserBeta
How the models work · Wall heat model

6. Stepping through time

The day is cut into 720 steps of two minutes. At each step the tool must find all the new slice temperatures from the old ones. It uses the implicit (backward Euler) method, where the heat flows are evaluated using the new temperatures, so the equation for each slice becomes:

(Ci ÷ Δt) (Tinew − Tiold) = Gi−1 (Ti−1new − Tinew) + Gi (Ti+1new − Tinew)

This looks circular, since the new temperatures appear on both sides, but each slice only touches its two neighbours, so the whole set can be solved quickly and exactly by a standard routine for tridiagonal systems (the Thomas algorithm). The implicit method is chosen because it stays stable however thin the slices or long the step. A simpler explicit scheme can blow up with thin, conductive slices.

Starting up and settling

The wall has to begin from some state. The tool starts it at the steady-state temperature profile for the day's average outside and inside temperatures, then repeats the same day again and again. In free-floating mode the room starts at the temperature where its gains and losses balance over the day. After a few days the wall has "forgotten" its starting guess and settles into a repeating daily cycle. It runs 6 days for the fixed and scheduled modes, and 14 days for the free-floating mode, where the room has to settle too. Only the final day is recorded: 144 snapshots, one every 10 minutes, plus a closing 24:00 frame.

That settled cycle is what you see. A real wall's temperatures also depend on what happened over previous days and weeks. This tool shows the repeating pattern you would get if every day were the same.