InsuliserBeta
How the models work · Moisture model

What the moisture model leaves out

Again, these are the main simplifications, so you know how far to trust the results.

  • Typical, not measured, weather. The year is built from monthly tables, with an even pattern of showers. There are no storms, heatwaves or cold snaps, and the driving rain is a fixed share of the rainfall rather than worked out from wind.
  • Typical material data. Each material's capillary and storage values are representative figures for its type from published hygrothermal data, not measured for a product. Real bricks and stones vary several-fold, so treat the comparison between build-ups as more reliable than the absolute amounts. Materials with no data are treated as not wicking or storing water, and are listed on the page.
  • No cracks or gaps. A render is treated as perfect. In practice rain often gets behind a cracked cement render and can't get out, which is a large part of its bad reputation on old walls. None of that is modelled.
  • No air leakage. Moist air leaking through gaps, joints and service penetrations can carry far more water than diffusion does.
  • No freezing. Ice in the pores isn't simulated, and the monthly weather never drops below 0 °C. The frost check therefore uses a fixed −5 °C night to find the part of the wall that can freeze, and judges how wet that part is over the winter, rather than counting real freeze–thaw cycles. Porosity is estimated, and the real frost resistance of a brick or stone can only be measured.
  • Ground moisture in one dimension. The wall is followed at a single height, 1 m above the footing, fed towards a moisture level that tapers from saturation at the base to dry at the front. The rise height uses sharp-front theory and the brick's own wicking, ignoring mortar bed joints, which usually wick more slowly, and the ground is taken as free water, so heights lean high. Salts, which hold water and drive much of the damage, are not modelled.
  • One dimension. A uniform wall, with no thermal bridges, window reveals, corners or junctions with the floor.
  • Mould as a single line. 80% surface humidity is a standard simplification. Real mould depends on the material, its temperature and how long the conditions last.