Conduction and R-values
Inside a solid wall, heat travels mainly by conduction: vibrating atoms pass energy to their neighbours. Some materials do this easily and some do not. A material's thermal conductivity, written k or λ and measured in W/mK, says how easily. Copper is very high, brick is moderate, and foam insulation is very low, because it traps tiny pockets of still gas that conduct poorly.
For a layer of a given thickness, what matters is its thermal resistance, R: how strongly it resists heat flow. Thicker layers resist more, and lower-conductivity materials resist more:
A 100 mm layer of insulation with k = 0.022 W/mK has R = 0.1 ÷ 0.022 ≈ 4.5 m²K/W. A 100 mm layer of brick with k = 0.8 has R = 0.125. The insulation resists heat roughly 36 times better, for the same thickness.
Resistances in layers add up, just as electrical resistors in series do. Heat has to push through every layer in turn. The surfaces matter too. A thin skin of slow-moving air clings to each face of a wall and resists heat flow a little. The tool uses a standard surface resistance of 0.04 m²K/W outside (where wind sweeps the air film away) and 0.13 m²K/W inside, or 0.10 for a roof, where warm air rises more readily.