InsuliserBeta
Concepts · Moisture

Condensation: surface and interstitial

Moisture does damage in the wall in two places.

On the inner surface
Air touching a surface cools towards the surface's temperature. If that pushes it past what the air can hold, water condenses. Even before that, mould can grow when the air at the surface stays above about 80% RH for long periods. A colder inner face (a poorly insulated wall) means higher surface humidity, which is why the inner-face temperature on the heat tab matters. The Moisture tab charts the surface RH for every month and marks the 80% line.
Inside the wall: interstitial condensation
Vapour does not stop at the inner surface. It diffuses into the wall, moving through the layers as the temperature falls. The cooler the layer, the less vapour the air in it can hold. If vapour pressure reaches that limit at a boundary between two layers, water condenses there, out of sight.
012002400stoneinternal insulationplastercondensationoutside: 750 Painside: 1170 Pa
Schematic only. Black: the vapour pressure that is actually in the wall. Dashed blue: the most the air can hold at the temperature of each point. Where they meet, the air is full.

Where does condensation happen? It needs vapour to reach a cold boundary, so what matters is which layers let vapour in and which let it out.

  • A vapour-tight layer (foam board, foil) stops most vapour entering the wall at all. Little water condenses behind it. But anything already in the wall, from rain or the ground, can't escape inwards, and gaps and air leaks around the boards can still carry moist air to the cold face.
  • A vapour-open layer (wood fibre, lime plaster) lets room vapour through to the cold boundary behind it, so some condensation is likely in winter. It also lets the wall dry back into the room in spring and summer.

Neither is simply "safe". What matters is whether the water that arrives in winter leaves again, and what the materials around it can tolerate. That is what the yearly simulation tests.